7.6 Standard toolsGeneralAll service (repairs, maintenance, and installation) procedures contains lists oftools required to perform the specified activity.All special tools required are listed directly in the procedures while all the toolsthat are considered standard are gathered in the standard toolkit and defined inthe following table.This way, the tools required are the sum of the standard toolkit and any tools listedin the instruction.Contents, standard toolkitRem.ToolQtyRing-open-end spanner 8-19 mm1Socket head cap 5-17 mm1Torx socket no: 20-601Box spanner set1Torque wrench 10-100 Nm1Torque wrench 75-400 Nm1Ratchet head for torque wrench 1/21Hexagon-headed screw M10x1002Hex bit socket head cap no. 14 socket 40 mm L=100 mm1To be shortened to 12 mmHex bit socket head cap no. 14 socket 40 mm L=20 mm1Hex bit socket head cap no. 6 socket 40 mm L=145 mm1Hex bit socket head cap no. 6 socket 40mm bit L=220 mm1Slide caliper Width=400 mm1Feeler gage, 0.4 mm1Bearing puller, three legs1Level1Product manual - IRB 760 3893HAC039838-001 Revision: M© Copyright 2011-2018 ABB. All rights reserved.7 Reference information7.6 Standard tools
