94 Copyright © Acronis, Inc., 2000-2010 Types of events to send – choose the types of events: All events, Errors and warnings, orErrors only. Server name/IP – type the name or IP address of the host running the SNMP managementapplication, the messages will be sent to. Community – type the name of the SNMP community to which both the host running SNMPmanagement application and the sending machine belong. The typical community is "public".To disable sending SNMP messages, clear the Send messages to SNMP server check box.The messages are sent over UDP.The next section contains additional information about Setting up SNMP services on the receivingmachine (p. 94).3.3.2.3 Setting up SNMP services on the receiving machineWindowsTo install the SNMP service on a machine running Windows:1. Start > Control Panel > Add or Remove Programs > Add/Remove Windows Components.2. Select Management and Monitoring Tools.3. Click Details.4. Select the Simple Network Management Protocol check box.5. Click OK.You might be asked for lmmib2.dll that can be found on the installation disc of your operatingsystem.LinuxTo receive SNMP messages on a machine running Linux, the net-snmp (for RHEL and SUSE) or thesnmpd (for Debian) package has to be installed.SNMP can be configured using the snmpconf command. The default configuration files are located inthe /etc/snmp directory: /etc/snmp/snmpd.conf - configuration file for the Net-SNMP SNMP agent /etc/snmp/snmptrapd.conf - configuration file for the Net-SNMP trap daemon.3.3.3 Log cleanup rulesThis option specifies how to clean up the Acronis Backup & Recovery 10 agent log.This option defines the maximum size of the agent log folder (in Windows XP/2003 Server,%ALLUSERSPROFILE%\Application Data\Acronis\BackupAndRecovery\MMS\LogEvents).The preset is: Maximum log size: 1 GB. On cleanup, keep 95% of the maximum log size.When the option is enabled, the program compares the actual log size with the maximum size afterevery 100 log entries. Once the maximum log size is exceeded, the program deletes the oldest logentries. You can select the amount of log entries to retain. The default 95% setting will keep most ofthe log. With the minimum 1% setting, the log will be nearly cleared.This parameter can also be set by using Acronis Administrative Template (p. 332).
