2 Verify if inbox Cisco-initiator is installed on a RHEL 4 setup, using one of thesecommands:• rpm -qf /sbin/iscsid• rpm -qa | grep iscsi-initiator-utilsIf the Cisco initiator is installed, the utility is displayed in the output.3 Set the Cisco initiator as the default initiator. The default initiator can bemodified in initiatorname.iscsi in /etc directory.For example, the default initiator name can be set as iqn.1987-05.com.cisco:rhel4.4 Set the target portal address, target name and the authentication details forCHAP login, in the iscsi.conf file present in /etc directory.• For iSCSI portal, uncomment the Discovery address parameter and enter the IPaddress.--------------------------# Discovery Address Category# --------------------------# To localize parameters to targets found on a particulardiscovery address# (i.e., to override the global settings), you need to use the# "DiscoveryAddress" setting. The format for the"DiscoveryAddress" setting is# a.b.c.d, a.b.c.d:e (where e is a TCP port number), or aninstance name. An# example of these settings would be:#DiscoveryAddress=10.161.205.92• For target name, uncomment TargetName parameter and enter the name of thetarget as listed in CLI.Note The target name should be modified only for using a particular target.--------------------------# Discovery Address Category# --------------------------# To localize parameters to targets found on a particulardiscovery address# --------------------# Target Name Category# --------------------# To localize parameters to targets identified by a particulartarget name# (i.e., to override the global settings), you need to use the# "TargetName" setting. The format for the "TargetName" settingis
