Modifying the Authentication SettingsYou can add authentication, change authentication methods, or removeauthentication from any provisioned volume or logical device. You can change theaccess settings for any provisioned volume or logical device.To change an authentication setting:1 In the Logical Devices View, right-click the words Logical devices, then selectModify logical devices.The wizard opens.2 Change the authentication settings as required. (For more detailed instructions,see Step 7 of “Provisioning Storage Manually” on page 42.)3 Click Next to continue, click Next again, then review the configuration summary.Click Back to change the configuration.4 Click Apply, then click Yes.The authentication settings are modified.Limiting User Access to Your IP SAN with the SecurityManagerTo protect your IP SAN, you can use Adaptec Storage Manager’s Security Managerto control which users can access and modify your iSCSI storage.Each Adaptec Storage Manager user is given a password and is assigned one of twoaccess privilege levels, Administrator level or Operator level (see page 87). To accessAdaptec Storage Manager and your IP SAN, the user enters his or her passwordwhen logging in to the Management Service (see Step 2 on page 35).Note Multiple users can be logged into the same Management Service at the same time.A user is associated with a specific Management Service. If your IP SAN includesmore than one Management Service, you can:• Add the same user to all Management Services, or limit that user to specificManagement Services only.• Assign the same user different privilege levels on different Management Services.Right-click here