2 Under Network settings, enter the values you prepared in “Before You Begin” onpage 34.Enter a name for the iSCSI Storage Appliance and the network domain to whichthe iSCSI Storage Appliance belongs.Enter a gateway name or IP address, or accept the default gateway.Enter IP addresses for up to three domain name servers, if required.3 (Optional) Under CLI settings, change the Administrator and Operator passwordsfrom their defaults. (By default, both passwords are ‘admin’.)4 Click Next, then set values for each Ethernet port on your iSCSI StorageAppliance, using the tabs at the top of the window to ensure that all ports areconfigured. Use static IP addresses for each port, and ensure that DHCP isdeselected.Note By default, Ethernet Port 0 is the management port and is used by theManagement Service to communicate with your iSCSI Storage Appliances; it isalso an iSCSI port. You can configure Ethernet Port 0 as a management port onlyby selecting that option in the Port Type drop-down menu.5 Click Next. By default, the current date and time is used for the iSCSI StorageAppliance. You can choose to manually set the date and time values, if required.Note The Adaptec OnTarget operating system does not automatically adjust thetime setting on your iSCSI Storage Appliance to accommodate Daylight SavingTime. However, the appliance uses the time setting for event timestamps only;the appliance time setting is not used for job schedules or other functions.6 Click Next, confirm the settings for this iSCSI Storage Appliance, then click Apply.DeselectDHCPClick tabs toview otherports
