3-82container Commandscontainer remove file_systemTo remove the file system from an array, use the containerremove file_system command. Use this command when thefile system on the array is no longer needed.This command fails if there are open files on the array.Command AvailabilityThis command is supported on Windows.Syntaxcontainer remove file_system {container}Parameters{container}Specifies the ID number (0 to 63) of the array from which youwant to remove the file system.ExamplesBefore removing a file system from an array, use the containerlist command to obtain information about any existing arrays.As the following example shows, there is an array 0 (a volume set)on this controller:AAC0>container listExecuting: container listNum Total Oth Stripe Scsi PartitionDr Label Type Size Ctr Size Usage C:ID:L Offset:Size-- ----- ------ ------ --- ------ ------- ------ -------------F: 0 Volume 10.0MB NTFS 0:02:0 64.0KB: 10.0MB
