9-11enclosure Commandsenclosure prepare slotTo indicate to the SAF-TE enclosure management device that itshould take the appropriate action to prepare the device in aspecific slot for removal or insertion, use the enclosureprepare slot command.This command may perform such operations as shutting off powerto the device slot. This allows users to safely remove a disk devicefrom or insert a disk device into the device slot.Syntaxenclosure prepare slot {enclosure} {slot}Parameters{enclosure}Specifies the ID associated with the enclosure managementdevice on which you want to prepare a slot. For this version,the controller supports a maximum of eight enclosuremanagement devices on each bus.{slot}Specifies the unit number associated with the slot. This is theslot that contains the device you want to prepare to makeavailable. This unit number can range from 0 to 15 inclusive.ExamplesBefore preparing a device in the slot, you might want to use theenclosure show slot command to determine the currentdevice slot status:AAC0>enclosure show slotExecuting: enclosure show slotEnclosure Slot scsiId Insert Status--------- ---- ------ ------- ----------------------------------------0 0 0:00:0 4 OK UNCONFIG ACTIVATE0 1 0:01:0 0 OK UNCONFIG ACTIVATE0 2 0:10:0 0 OK UNCONFIG ACTIVATE0 3 0:03:0 0 OK UNCONFIG ACTIVATE0 4 0:04:0 0 OK UNCONFIG ACTIVATE1 0 1:00:0 0 OK CONFIG ACTIVATE1 1 1:01:0 0 OK UNCONFIG ACTIVATE1 2 1:10:0 0 OK UNCONFIG ACTIVATE1 3 1:03:0 0 OK UNCONFIG ACTIVATE1 4 1:04:0 0 OK UNCONFIG ACTIVATE
