3-103container Commandscontainer show cacheTo display the current cache parameters associated with a specificarray, use the container show cache command. Typically, youuse this command after setting cache parameters for a specificarray using the container set cache command.Syntaxcontainer show cache {container}Parameters{container}Specifies the ID number (0 to 63) of the array whoseassociated cache parameters you want to display.ExamplesBefore setting cache parameters for a specific array, use thecontainer list command to obtain information about anyexisting arrays.As the following example shows, there is an array 0 (a volume set)on this controller with no file system on it (as evidenced by Nonedisplayed in the Usage column). Assume the cache parameters forthis array were previously set with the container set cachecommand:AAC0>container listExecuting: container listNum Total Oth Stripe Scsi PartitionDr Label Type Size Ctr Size Usage C:ID:L Offset:Size-- ----- ------ ------ --- ------ ------- ------ -------------0 Volume 15.0MB None 0:02:0 64.0KB: 15.0MBThe following example displays cache parameters for array 0:AAC0>container show cache 0Executing: container show cache 0Global container Read Cache Size : 5345280Global container Write Cache Size : 1970176Read Cache Setting : ENABLEDWrite Cache Setting : ENABLEDWrite Cache Status : ENABLED
