9-19enclosure Commandsenclosure set powerTo turn the power of a specific power supply on a specific SAF-TEenclosure management device on or off, use the enclosure setpower command. Typically, most enclosure management devicesturn on their associated power supplies by default after power up.Syntaxenclosure set power [/off{=boolean}] {enclosure}{powersupply}Parameters{enclosure}Specifies the ID associated with the enclosure managementdevice on which you want to turn the power of a specificpower supply on or off. For this version, the controllersupports a maximum of eight enclosure management deviceson each bus.{powersupply}Specifies the unit number associated with the power supplywhose power you want to turn on or off. The unit number forthe power supply can range from 0 to 15 inclusive.Switches/off{=boolean}Specifies whether to turn the power supply associated withthe specified unit number on or off. If you set this switch toTRUE, the command turns off the power supply associatedwith the specified unit number. If you specify FALSE, thecommand turns on the power supply associated with thespecified unit number.This switch defaults to FALSE, which means the commandturns on the power supply if you do not specify the switch.
