4-9controller Commandscontroller firmware updateTo update a controller’s flash components from the flash imagedata in a pair of user flash image (UFI) files, use the controllerfirmware update command. This command can update theflash components on a single controller or multiple controllers.Syntaxcontroller firmware update[/C[{controller_ID}][{controller_ID}...]{/D{UFI_file_path}]Switches/C{controller_ID}Specifies the controller ID representing the set of controllerson which to perform the firmware update.If you do not specify this switch, the firmware update isperformed on controller 0./D{UFI_file_path}Specifies the path where the pair of UFI files are located.If you do not specify this switch, this command looks for orcreates a pair of UFI files in the current default drive anddirectory.ExamplesThe following example updates a controller’s firmware.AAC0> controller firmware update D:\...Executing: controller firmware compare “D:\...”!!The controller’s firmware has been successfully updated; you need torestart the system!!.Related Commandscontroller commands: controller firmware compare (page 4-6) controller firmware save (page 4-7)
