Winding/Installing the BobbinB-12Winding the bobbinThis section describes how to wind thread onto a bobbin.aOpen the top cover.bPlace the bobbin on the bobbin winder shaft so that thespring on the shaft fits into the notch in the bobbin.Press down on the bobbin until it snaps into place.1 Notch2 Bobbin winder shaft springc Slide the bobbin winder in the direction of the arrowuntil it snaps into place.• The “Start/Stop” button lights up in orange.dRemove the spool cap that is inserted onto the spoolpin.1 Spool pin2 Spool capePlace the spool of thread for the bobbin onto the spoolpin.Slide the spool onto the pin so that the spool ishorizontal and the thread unwinds to the front at thebottom.• If the spool is not positioned so that the threadunwinds correctly, the thread may become tangledaround the spool pin.Winding/Installing the BobbinCAUTION• Only use the Bobbin (part code: X52800-120)designed specifically for this machine. Use ofany other bobbin may result in injuries ordamage to the machine.• The included bobbin was designed specificallyfor this machine.If bobbins from other models are used, themachine will not operate correctly. Use onlythe included bobbin or bobbins of the sametype (X52800-120).X52800-120 is Class15 type bobbin.* Made of plastic1 This model2 Other models3 11.5 mm (approx. 7/16 inch)Memo• When the foot controller is connected, bobbinwinding can be started and stopped with the footcontroller.2112