Upper ThreadingGETTING READYBasic operations B-23BcManually thread the left needle with the upper thread.Pass the thread through the eye of the needle from thefront.d Insert the horizontal spool pin onto the bobbin windershaft.Insert the horizontal spool pin so that it is perpendicularto the bobbin winder shaft.1 Bobbin winder shafte Swing the spool pin toward the left so that it ishorizontal.f Place the upper thread spool for the needle on the rightside onto the horizontal spool pin, and then secure itwith the spool cap.The thread should unwind from the front at the bottomof the spool.1 Spool cap2 Spoolg Thread the upper thread in the same way that theupper thread for the left side was threaded.1 Thread guide cover• For details, refer to steps h through j of“Threading the upper thread” on page B-18.h Without passing the thread through the needle barthread guide, manually thread the right needle.Insert the thread through the eye of the needle from thefront to the back.• The needle threader cannot be used with the twinneedle. If the needle threader is used with the twinneedle, the machine may be damaged.iAttach zigzag foot “J”.• For details on changing the presser foot, refer to“Replacing the presser foot” on page B-28.jTurn on the machine and select a stitch.• For stitch selection see “Selecting a stitch pattern” onpage B-31.• See “Stitch Setting Chart” on page B-39 for stitchesthat use a twin needle.11 2CAUTION• When using the twin needle, be sure to attachzigzag foot “J”. If bunched stitches occur, usemonogramming foot “N” or attach stabilizermaterial.CAUTION• When using the twin needle, be sure to selectan appropriate stitch, otherwise the needlemay break or the machine may be damaged.1
