FeaturesBasler sprint Color Cameras 2236.15 Configuration SetsA configuration set is a group of values that contains allof the parameter settings needed to control the camera.There are three basic types of configuration sets: thework configuration set, the factory configuration set,and user configuration sets.Work Configuration SetThe work configuration set contains the camera’scurrent parameter settings and thus determines thecamera’s performance. If you use the CCT+ to changethe camera settings or if you change settings by writingto the camera’s registers, you are making changes tothe work configuration set. The work configuration setresides in the camera’s volatile memory and the settings are lost if the camera is reset or if poweris switched off. The work configuration set is usually just called the “work set” for short.Factory Configuration SetWhen a camera is manufactured, a test setup is performed on the camera and an optimizedconfiguration is determined. The factory configuration set contains the camera’s factory optimizedparameter settings. The factory set is saved in a permanent file in the camera’s non-volatilememory. The factory set can not be altered by the user and since it is stored in non-volatile memory,it is not lost when the camera is reset or switched off. The factory configuration set is usually justcalled the “factory set” for short and is named FactorySet.User Configuration SetsAs mentioned above, the work configuration set resides in the camera’s volatile memory, and theparameters settings in the work set are lost if the camera is reset or is switched off. The camera cansave the parameter settings from the current work set to a file in the camera’s non-volatile memory.Files in the non-volatile memory are not lost when the camera is reset or switched off. There arefour files in the camera’s non-volatile memory available for holding a saved configuration set. Aconfiguration set saved in one of these files is commonly referred to as a "user configuration set" or"user set" for short.The four files available for holding a saved user configuration set are called UserSet01, UserSet02,UserSet03, and UserSet04.Fig. 85: Configuration SetsUserSet01UserSet02UserSet03UserSet04Work SetFactory SetNon-volatileMemory(flash)VolatileMemory(RAM)
