Physical Interface26 Basler sprint Color Cameras2.1 General Description of the ConnectionsThe camera is interfaced to external circuitry via connectors located on the back of the housing: one or two, 26-pin, 0.050 inch Mini D Ribbon (MDR) female connectors used to transfer pixeldata, control data, and configuration data. The number of MDR connectors present on thecamera varies by camera model as shown in Table 4. a 6-pin, micro-miniature, push-pull receptacle used to provide power to the camera.An LED located on the back of the camera is used to indicate power present and to display thecamera’s status. Figure 14 shows the connectors and the LED for 2k and 4k cameras. Theconnectors and the LED for 8k cameras are analogous.Fig. 14: Connectors and LED (2k and 4k cameras; 8k cameras are analogous)Model MDR Connectors Camera Link ConfigurationspL2048-39kc MDR Conn. 1 only BasespL2048-70kc, spL4096-39kc,spL4096-70kc, spL8192-39kcMDR Conn. 1 and MDR Conn. 2 Medium/fullTable 4: MDR Connectors by Camera ModelCamera Link medium / fullCamera Link base12 VDCMDR Conn. 226-Pin Female MDR Connector(only present on Camera Linkmedium/full configuration cameras)LED6-PinMicro-miniatureReceptacleMDR Conn. 126-Pin Female MDR Connector(present on all cameras)
