Cabletron Systems SmartSwitch 9W006 Quick Start Manual

Also see for SmartSwitch 9W006: User guide Release note User guide

Contents

9W006 and 9W007 11I NSTALLING THE M ODULEAccessing the ModuleFor non-U.S. and European installations, standard cabling is sufficient (refer to following section).M ODULE TO PRI S ERVICE CABLINGPRI cabling is not included. You will need to determine the length of cable you need for yourconnection. PRI cabling is straight-through twisted-pair cable with RJ-45 adapters at each end.1. Insert the RJ-45 adapter at one end of the PRI cable into either the Mod-Tap adapter (U.S. andEurope) or directly into the module’s PRI port 1 (for all other installations).2. Insert the RJ-45 adapter at the other end of the PRI cable into your PRI service drop.3. Repeat steps 2 and 3 for PRI ports 2, 3, and 4 if applicable.RESETTING THE SMARTS WITCH REMOTE A CCESS M ODULEThe reset switch is a recessed switch located on the front panel, under the top-left plastic ejector tab.The reset switch serves two functions:1. Pressing the reset switch twice within three seconds causes the processor to reset.2. Pressing and holding the switch on for three or more consecutive seconds causes the moduleto shutdown. Pressing and holding the switch again for three seconds restarts the module.SNMP management may be used to disable this switch to enhance module security.A CCESSING THE M ODULEThis section provides instructions for:• accessing a SmartSwitch Remote Access Module for the first time• remotely accessing the SmartSwitch Remote Access Module after the first timeRJ-45PinoutAdapterRJ-45Pinout12345678inserts intoPRI port12345678TX+RX+RX-TX-RX+RX-TX+TX-Mod-TapAdapterinsert one end of PRI cable here,other end into PRI service drop