Black plate (90,1)Cadillac STS Owner Manual - 201110. Inflate the tire to the recommended inflationpressure using the pressure gauge (C). Therecommended inflation pressure can be found onthe Tire and Loading Information label. SeeInflation - Tire Pressure on page 6‑58.The pressure gauge (C) may read higher than theactual tire pressure while the compressor is on.Turn the compressor off to get an accuratepressure reading. The compressor may be turnedon/off until the correct pressure is reached.Notice: If the recommended pressure cannot bereached after approximately 25 minutes, the vehicleshould not be driven farther. The tire is too severelydamaged and the tire sealant and compressor kitcannot inflate the tire. Remove the power plug fromthe accessory power outlet and unscrew theinflating hose from the tire valve. See RoadsideService on page 8‑8.11. Press the on/off button (B) to turn the tire sealantand compressor kit off.The tire is not sealed and will continue to leak airuntil the vehicle is driven and the sealant isdistributed in the tire, therefore, Steps 12 through18 must be done immediately after Step 11.Be careful while handling the tire sealant andcompressor kit as it could be warm after usage.12. Unplug the power plug (H) from the accessorypower outlet in the vehicle.13. Turn the sealant/air hose (F) counterclockwise toremove it from the tire valve stem.14. Replace the tire valve stem cap.15. Replace the sealant/air hose (F), and the powerplug (H) back in their original location.16. If the flat tire was ableto inflate to therecommended inflationpressure, remove themaximum speed labelfrom the sealantcanister (E) and placeit in a highly visiblelocation.Do not exceed the speed on this label until thedamaged tire is repaired or replaced.17. Return the equipment to its original storagelocation in the vehicle.18. Immediately drive the vehicle 8 km (5 miles) todistribute the sealant in the tire.6-90
