6-96SENDING DOCUMENTSRedialling when the line is busyThere are two methods of redialling: manual redialling and automatic redialling. This section explains thesetwo methods.Manual redialling ____________________________Press [Redial/Pause] to dial the last number you dialled with the numeric buttons. (This starts rediallingregardless of whether automatic redialling is enabled.)KK Cancelling manual rediallingTo cancel manual redialling, press [Stop].Automatic redialling _________________________KK What is automatic redialling?When you are sending a document using memory sending and the receiving party’s line is busy, the faxwaits the specified time and then dials the same number again. You can set the fax to redial several times ifprevious attempts fail because of a busy signal. This feature is called automatic redialling.After the initial dial attempt, the fax will try to dial again. Automatic redialling can be turned off and on.The number of redialling attempts and the time interval between attempts can also be adjusted. (see AUTOREDIAL, p. 8-4)If all redialling attempts are unsuccessful, the fax will cancel the transmission and print an ERROR TXREPORT to remind you that the transmission was not completed. (see p. 8-11)When automatic redialling is in use, the LCD alternately displays AUTO REDIAL and the transactionnumber (TX/RX NO. xxxx) while the fax is waiting to redial.
