108EEditingOUTPUTAUDIOLRYou can add sound to the original sound on a pre-recorded tape from audio devices (AUDIO IN) orwith the internal or external microphone (MIC. IN). The original sound will not be erased.If there are non-recorded portions on the tape, or portions recorded in a mode other than SPmode, or with 16-bit or 12-bit 4-channel sound, dubbing will stop. If your tape has not beenrecorded in SP mode with 12-bit sound, we recommend dubbing your original tape onto a blanktape using the GL2’s analog line-in function, then dubbing audio onto the new tape. Makeabsolutely sure to set the audio mode of the new tape to 12-bit and the recording mode to SP.To connect other audio devices:Note:• No video picture will be output via the AV terminal. Check the picture on the LCD screen,viewfinder or a TV connected to the S-video terminal. Check the sound using the speaker orheadphones.To connect an external microphone:STV-250NStereo VideoCableAn audio device(i. e. CD player): Signal flowNotes:• When using the built-in microphone for dubbing, make sure that no cables are connected to theMIC terminal.• If you connect a TV to the S-video terminal, you can monitor the picture on the TV screen. Useheadphones to check the sound.Audio DubbingAdd sound to tapes that have been recorded with this camcorder in SP mode with 12-bit sound.
