111EEditingAUDIOMONITORMIXBALANCEST-1 ST-2When you play back a tape that was recorded in 12-bit mode, you can set the audio output tostereo 1 (the original sound), stereo 2 (any new sound, dubbed to the tape after recording), or mixthe balance between the two.• Audio from the 16-bit mode only contains stereo 1 sound and so you cannot/do not need toselect the audio mix. The same applies to the 12-bit stereo 1 mode, unless new sound has beenadded post-recording.Select the output channel.• Press AUDIO MONITOR on the wireless controller.• Starting with the last selected setting, 4 settings appear as you push the button:– STEREO1 for just stereo 1.– STEREO2 for just stereo 2.– MIX/FIXED for an equal mix of stereo 1 and 2.– MIX/VARI. (mix variable) for when you want to mix the balance between stereo 1 and 2.• If you choose MIX/VARI., you can go on to mix the balance.• Use the ST-1/ST-2 buttons to mix the balance. A bar showing the balance appears on thescreen for 4 seconds.Note:• When you have chosen the output, STEREO1, STEREO2, MIX/FIXED or MIX/VARI. is shown in thetop left of the display for a few seconds. If you turn the power off, the output becomes set toSTEREO1.+ PLAY(VCR)TAPESetting the Audio Mix
