10-8 Troubleshooting Chapter 10Message Error Code Cause ActionDIALING — The MultiPASS is Press STOP if youdialing the receiving want to cancel thefax machine. transmission.DOC TOO LONG #003 It took more than 32 Divide the documentminutes to send or and send or copy eachcopy a document. part separately.It took more than 32 Contact the other party.minutes to receive a Have them divide thedocument. document and sendeach part separately.The document is longer Use a copy machine tothan 39.4 inches (1 m). make a reduced copy ofthe document and sendthe copy.DOCUMENT READY — The document in the Send the fax, scan theADF is ready for faxing, document, or make thescanning, or copying. copy.ECM RX — The MultiPASS is ECM transmissions mayreceiving a fax take longer than normalusing ECM. transmissions. Turnoff ECM if you need toreceive quickly, or if youknow your local linesare in good condition.ECM TX — The MultiPASS is ECM transmissions maysending a fax using take longer than normalECM. transmissions. Turn offECM if you need totransmit quickly, or ifyou know your locallines are in goodcondition.HANG UP PHONE — The telephone is Place the telephoneoff hook. properly into its cradle.INSTALL BC-20/21 — The BC-22e or BC-29F Remove the BC-22e orBJ Cartridge is installed, BC-29F BJ Cartridgeso the MultiPASS cannot and install the BC-21eprint any received faxes, or BC-20 BJ Cartridge.or make copies.INSTALL BC-21 — The BC-20, BC-22e, Remove the BC-20,or BC-29F BJ Cartridge BC-22e, or BC-29Fis installed. BJ Cartridge and installthe BC-21e BJ Cartridge.LOAD PAPER — The MultiPASS is out Load paper in the sheetof paper (the sheet feeder. Make sure thefeeder is empty). stack does not exceedthe limit mark. Thenpress START/COPY.
