iiiUSERS IN U.S.A.PRE-INSTALLATION REQUIREMENTS FOR CANONFACSIMILE EQUIPMENTA. LocationSupply a suitable table, cabinet, or desk. See Appendix A for the unit’sdimensions and weight.B. Order Information1. Only a single line, touch-tone or rotary telephone set is to be used.2. Order an RJ11-C modular jack (USOC code), which should beinstalled by the phone company. If the RJ11-C jack is not present,installation cannot occur.3. Order a normal business line from your telephone company’s businessrepresentative. The line should be a regular voice grade line orequivalent. Use one line per unit.DDD (DIRECT DISTANCE DIAL) LINEorIDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IF YOUCOMMUNICATE OVERSEASN Canon recommends an individual line following industry standards [e.g., the2500 (touch-tone) or 500 (rotary/pulse dial) telephones]. A dedicated extensionoff a PBX unit without “Call Waiting” can be used with your MultiPASS C3500.Key telephone systems are not recommended because they send non-standardsignals to individual telephones for ringing and special codes, which may causea fax error.C. Power RequirementsThis equipment should be connected to a standard 120 volt AC, three-wiregrounded outlet only. Do not connect this unit to an outlet or power lineshared with other appliances that cause “electrical noise.” Air conditioners,electric typewriters, copiers, and machines of this sort generate noise whichoften interferes with communications equipment and the sending andreceiving of documents.CONNECTION OF THE EQUIPMENTThis equipment complies with Part 68 of the FCC rules. On the rear panel ofthis equipment is a label that contains, among other information, the FCCRegistration Number and Ringer Equivalence Number (REN) for thisequipment. If requested, this information must be given to the telephonecompany. This equipment may not be used on coin service provided by thetelephone company. Connection to party lines is subject to state tariffs.
