39Setting Up the Machine and the Computer (Windows)ENGLISHSetting up an additional LAN-connected computerThis section describes how to set up a computer so that you can use the machine that hasalready been set up using another computer to connect to a wireless or wired LAN. This setupprocedure only requires settings to be performed on the client computer.1 Turn on the machine.It takes about 40 seconds until the POWER lamplights up green.2 On the Setup Method screen, select Set uponly the computer and click Next.ImportantFollow this procedure only when the machine has already been connected to a wireless or wiredLAN. If the machine has not been connected to a network yet, see “Setting up for use over wirelessLAN” on page 27 or “Setting up for use over wired LAN” on page 33 depending on your connectiontype.Notez If MAC or IP address filtering is configured to restrict access to the machine, make surebeforehand to register those addresses of the computer you are setting up.To do this, use the Canon IJ Network Tool on a computer that is already set up.z Make sure that the computer you are setting up is NOT connected to the machine via a USBcable. This setup procedure does not involve connecting the USB cable.z For wired LAN connections, make sure that the machine is connected to the network with a LANcable.ImportantThis step should follow from step 4 in “Installing theSoftware” on page 24. If the Setup Method screenhas not displayed yet, go back to the procedure in“Installing the Software” on page 24 to complete theinstallation of the software.
