70 TroubleshootingENGLISHThe Set Printer IP Address dialog boxis displayed during setup(Continued)(1)TCP/IP SettingSelect Get IP address automatically or Use following IP address. SelectGet IP address automatically to search for the target printer automatically.If it fails, check the network settings and the network connection.IP Address/Subnet Mask/RouterEnter each value to specify a fixed IP address when Use following IPaddress is selected.(2)Network InformationClick to display the Network Information dialog box, and confirm networksettings when your access point or your machine cannot be detectedautomatically during setup for use over the network. This button is enabledwhen an access point was not detected or could not be connected.(3)ConnectClick to search for the machine with the specified settings. If the machine isstill not be detected with a specified IP address, see “Cannot connect to themachine (the machine is not detected)” on page 66.NoteClicking Back displays the Access Points dialog box.The Enter Password / PasswordInput dialog box is displayed duringsetupThe following dialog box is displayed if an administrator password is set to themachine which has already been set up.Admin PasswordEnter the administrator password you have set. The administrator passwordconsists of alphanumeric characters and is no longer than 32 characters. Thepassword is case sensitive.For security, your entry will be displayed by “*” (asterisks) in Windows and “•”(bullets) in Macintosh.“You have connected the printer to anunsecured wireless network” isdisplayed during setupThe encryption settings are not configured on the access point.The machine can still be used, so continue the setup procedure to complete it.ImportantIf you connect to a network that is not protected with security measures, there isa risk of disclosing data such as your personal information to a third party.Problem Possible Cause and Measures(1)(2)(3)
