121Customization 4Custom Picture SettingsSharpnessSets the sharpness of the output and recording signal.[Level]: Sets the sharpness level. This setting can be adjustedfrom -10 to 50. (Default: 0)[H Detail Freq.]: Sets the center frequency of horizontal sharpness.Setting higher values increases the frequency, which, inturn, increases the sharpness. This setting can beadjusted from -8 to 8. (Default: 0)[Coring]: Reduces noise artifacts caused by high sharpness levels.[Level]: Sets the coring level. Higher values prevent sharpness frombeing applied to minute details, resulting in less noise. This setting canbe adjusted from -30 to 50. (Default: 0)[D-Ofst]: You can use [D-Ofst], [D-Curve] and [D-Depth] to adjust thecoring level based on brightness. [D-Ofst] sets the coring level of theminimum brightness level. This setting can be adjusted from 0 to 50.(Default: 0)[D-Curve]: Sets the curve of the coring adjustment. This curve is thechange from [Level] to [D-Ofst]. This setting can be adjusted from 0 to 8.(Default: 0)[D-Depth]: Sets a multiplier to [D-Ofst] that determines the coring leveladjustment based on brightness. Positive values raise the coring levelin dark areas and negative values lower the level. This setting can beadjusted from -4 to 4. (Default: 0)[HV Detail Bal.]: Adjusts the ratio between horizontal and vertical detail.Higher values emphasize vertical detail while lower valuesemphasize horizontal detail. This setting can be adjustedfrom -8 to 8. (Default: 0)[Limit]: Restricts how much sharpness is applied. This settingcan be adjusted from -50 to 50. (Default: 0)InputOutputInputOutputKnee Slope Knee PointCOPYDownloaded From VideoCamera-Manual.com Manuals
