11-2 Connecting to the NetworkStages of installation on the networkInstallation can be performed by a network or printing administrator. The stages of asuccessful installation are:• Physically connecting the ColorPASS to a functioning networkPrepare a network node for the ColorPASS—obtain cable and route it to the locationwhere the ColorPASS will be installed (near the copier) and attach the cable to thenetwork interface of the ColorPASS. See page 2-9 for details.N OTE : If you plan to run the Command WorkStation software, you will need to installthe software and connect the Command WorkStation computer to the network alongwith the ColorPASS. See Getting Started for details.• Configuring the network serverWhen network servers are required, you need to configure those servers to provideclient access to the ColorPASS as a color PostScript printer. See Chapter 5 forinformation on configuring network servers in Windows and UNIX networkenvironments.• Setting up the ColorPASSConfigure the ColorPASS for your particular printing and network environment. Firstread Chapter 2, and then see the following chapters for details.• Preparing client workstations for printingInstall the files needed for printing, install additional user software, and connect theclient to the ColorPASS over the network. These steps are described in Getting Started,and some information is provided in Chapter 5 of this manual.• Administering the ColorPASSMonitor and maintain system performance and troubleshoot problems that arise. SeeChapter 6 and the Job Management Guide for details.
