33-21 Network Setup optionsClear Frame TypesYou can clear all frame types at once by choosing Exit IPX/SPX Setup, then choosingIPX/SPX Setup and selecting Clear Frame Types.Select Frame TypesEnable IPX Auto Frame TypeYes/No [Yes]Specify whether the ColorPASS should try to bind to all available frame typesautomatically. The ColorPASS does so whether or not all frame types are appropriate.To determine the frame types that were successfully bound, save your changes, exitSetup, allow the ColorPASS to reboot, and print a Configuration page. TheConfiguration page lists only one of the frame types that were successfully bound.If you answer No to this option, you can select frame types manually. You must chooseat least one frame type to enable IPX/SPX protocols.The frame selection screen allows you to make multiple selections. Depending on yourPort Setup selection, only Ethernet frame types, only Token Ring frame types, or allframe types are displayed.Press the line selection button beside each frame type used on your IPX/SPX network.An asterisk (*) appears beside each selected frame type. Press the line selection buttonagain to deselect a frame type. Use the up and down buttons to scroll to additionalframe types. The ColorPASS binds to each frame type as you select it.When you have selected all the frame types used, choose Exit IPX/SPX Setup.Exit IPX/SPX SetupSelect Frame TypesClear Frame TypesIPX/SPX SetupExit IPX/SPX SetupEthernet 802.2 *Ethernet 802.3Ethernet IIIPX/SPX Setup
