1 Introduction1.1 How to Read This Programming Guide1.1.1 Purpose of the ManualThe FC 360 Programming Guide provides informationabout controlling the frequency converter, parameteraccess, programming, and troubleshooting.The Programming Guide is intended for use by qualifiedpersonnel who are familiar with the FC 360 frequencyconverter.Read the instructions before programming and follow theprocedures in this manual.VLT® is a registered trademark.1.1.2 Document and Software VersionThis manual is regularly reviewed and updated. Allsuggestions for improvement are welcome. Table 1.1 showsthe document version and the corresponding softwareversion.Edition Remarks Software versionMG06C4 Replaces MG06C3 1.3X1.1.3 Abbreviations and ConventionsAC Alternating currentAEO Automatic Energy OptimisationAWG American Wire GaugeAMA Automatic Motor Adaptation°C Degrees CelsiusDC Direct currentEMC Electromagnetic compatibilityETR Electronic thermal relayfM,N Nominal motor frequencyFC Frequency converterHO High overloadIP Ingress protectionILIM Current limitIINV Rated inverter output currentIM,N Nominal motor currentIVLT,MAX Maximum output currentIVLT,NRated output current supplied by thefrequency converterLCP Local Control PanelN.A. Not applicableNO Normal overloadPM,N Nominal motor powerPCB Printed circuit boardPE Protective earthPELV Protective Extra Low VoltagePM motor Permanent magnet motorRegen Regenerative terminalsRPM Revolutions per minuteTLIM Torque limitUM,N Nominal motor voltageTable 1.1 AbbreviationsConventions• Numbered lists indicate procedures.• Bullet lists indicate other information anddescription of illustrations.• Italicised text indicates:- cross reference- link- footnote- parameter name, parameter groupname, parameter optionIntroduction Programming Guide6 Danfoss A/S © Rev. 2014-03-31 All rights reserved. MG06C40211
