3 - 55Chapter 3 Removal and Replacement Procedures (RRPs)Version 3 2007.03.15Removal 31 FAN (PL9.1.10)Steps 1 through 6 are for reference. Before removing this component, check that Steps 1 through 6have been performed.1) Open the FRONT COVER (PL1.2.1).2) Remove the FUSER. (Removal 8)3) Remove the REAR COVER. (Removal 12)4) Remove the RIGHT COVER. (Removal 13)5) Remove the LEFT COVER. (Removal 22)6) Remove the TOP COVER. (Removal 30)7) Disengage the connector (P/J503) of the FAN (PL9.1.10) on the LOW VOLTAGE POWERSUPPLY (PL9.1.4).8) Remove the harness of the FAN by releasing the clamps.9) Release the harness of the FAN from the hook of the printer.10) Remove the two screws (silver, tap, 35mm) that fix the DUCT FAN MAIN (PL9.1.36) and FANtogether to the printer.11) Remove from the printer the DUCT FAN MAIN together with the FAN.12) Remove the two screws (silver, tap, 35mm) that fix the FAN to the DUCT FAN MAIN.13) Remove the FAN from the DUCT FAN MAIN.Go to the next removal steps:Removal 32 HIGH VOLTAGE POWER SUPPLY (PL5.1.17) or Removal 33 LOW VOLTAGEPOWER SUPPLY (PL9.1.4)Kmy03044KD7)8)11)8)12)12)13)9)10)10)