3 - 128Chapter 3 Removal and Replacement Procedures (RRPs)Version 2 2006.03.31Replacement 31 FEED DRIVE ASSEMBLY (PL8.1.7)1) Engage the connector (P/J251) of the FEED DRIVE ASSEMBLY.When performing the step described below, the harness of the connector to be engagedto the DEVE MOTOR of the PHOTOCONDUCTOR (PC) / DEVELOPER (DEV) DRIVE(PL8.1.2) must be routed through the hook above the FEED DRIVE ASSEMBLY.2) Replace the FEED DRIVE ASSEMBLY by mating the two holes of the FEED DRIVE ASSEM-BLY with the bosses on the printer.3) Secure the FEED DRIVE ASSEMBLY to the printer using the four screws (silver, tap, 10mm).Continues to the next page.Kmy03078KBNOTE3)3)2)1)3)3)
