3 - 98Chapter 3 Removal and Replacement Procedures (RRPs)Version 3 2007.03.15Replacement 15 FAN (PL9.1.10)When performing the step described below, take care to check the orientation of the FAN.(Attach the FAN so that its labeled surface faces front.)When performing the step described below, route the harness of the FAN through thenotch of the DUCT FAN MAIN.1) Mate the notch of the FAN with the rib of the DUCT FAN MAIN and attach the FAN to theDUCT FAN MAIN.2) Secure the FAN to the DUCT FAN MAIN using the two screws (silver, tap, 35mm)3) Route the harness of the FAN into the printer, and replace the DUCT FAN MAIN and FANtogether to the printer.4) Secure the DUCT FAN MAIN and FAN together to the printer using the two screws (silver,tap, 35mm).5) Adjust the length of the harness by winding the harness of the FAN to the hook of the printer,and route the harness along the printer.6) Engage the connector (P/J503) of the FAN to the LOW VOLTAGE POWER SUPPLY.7) Secure the harness of the FAN with the clamp.Go to the next replacement step:Replacement 16 TOP COVER (PL1.1.1)Kmy03104KDLABEL[NOTE] NOTE6)7)3)7)5)4)4)2)2)1)-21)-1
