4. Enter the parameters for accessing the virtual machine as described in the following table.Option DescriptionVirtual MachineNameEnter a name for the virtual machine being created.NOTE: It is recommended to use a name that is derived from the agentname or one that matches the agent name. You can also create a namederived from the hypervisor type, IP address or DNS name.Target Path Specify a local or remote target path to create the virtual machine.NOTE: The target path should not be a root directory.If you specify a network share path, you will need to enter valid logoncredentials (user name and password) for an account that is registered on thetarget machine. The account must have read and write permissions to thenetwork share.Memory Specify the memory usage for the virtual machine by clicking one of thefollowing:• Click Use the same amount of RAM as the source machine to identify thatthe RAM use is identical between the virtual and source machines.• Click Use a specific amount of RAM to specify how much RAM to use; forexample, 4096 MB. The minimum amount allowed is 512 MB and themaximum is determined by the capability and limitations of the hostmachine. (recommended)5. To specify a user account for the virtual machine, select Specify the user account for the exportedvirtual machine, and then enter the following information. This refers to a specific user account forwhich the virtual machine will be registered in the event there are multiple user accounts on thevirtual machine. When this user account is logged on, only this user will see this Virtual Machine inVirtualBox manager. If an account is not specified, then the Virtual Machine will be registered for allexisting users on the Windows machine with VirtualBox.• User name - Enter the user name for which the virtual machine is registered.• Password - Enter the password for this user account.6. Select Perform initial one-time export to perform the virtual export immediately instead of after thenext scheduled snapshot.7. On the Volumes page, select the volume(s) to export. For the virtual machine to be an effectivebackup of the protected machine include the protected machine’s boot drive. Example. C:\.8. On the Summary page, click Finish to complete the wizard and to start the export.NOTE: You can monitor the status and progress of the export by viewing the Virtual Standby orEvents tab.Virtual Machine ManagementThe VM Management tab displays the status of the protected machines. You can start, stop, and addnetwork adapters (applicable for Hyper-V and ESXi virtual machines only). To navigate to the VMManagement tab, click Appliance → VM Management.NOTE: The Start, Stop and Add Network Adapter buttons may take up to 30 seconds to appear eachtime the Appliance → VM Management tab is selected.125
