8. Click OK.NOTE: You must restart the Core service for the changes to take effect.Modifying engine settingsTo modify the engine settings:1. Navigate to the Core Console.2. Click Configuration → Settings3. In the Replay Engine Configuration pane, click Change.The Replay Engine Configuration dialog box appears.4. Enter the configuration information described as follows:Text Box DescriptionIP address • To use the preferred IP address from your TCP/IP, click AutomaticallyDetermined• To manually enter an IP address, click Use a specific address.Preferable Port Enter a port number or accept the default setting (8007 is the default port).The port is used to specify the communication channel for the engine.Port in use Represents the port that is in use for the Replay Engine configuration.Allow port auto-assigningClick for allow for automatic TCP port assignment.Admin Group Enter a new name for the administration group. The default name is BUILTIN\Administrators.Minimum AsyncI/O LengthEnter a value or choose the default setting. It describes the minimumasynchronous input/output length. The default setting is 65536.Receive BufferSizeEnter an inbound buffer size or accept the default setting. The default setting is8192.Send Buffer Size Enter an outbound buffer size or accept the default setting. The default settingis 8192.Read Timeout Enter a read timeout value or choose the default setting. The default setting is00:00:30.Write Timeout Enter a write timeout value or choose the default setting. The default setting is00:00:30.No Delay It is recommended that you leave this check box unchecked as doingotherwise will impact network efficiency. If you determine that you need tomodify this setting, contact Dell Support for guidance.5. Click OK.28