3. In the Universal Recovery Console, click Driver Injection.4. To locate the compressed driver file, navigate through the filing system and select the file.5. If you clicked Driver Injection in step 3, click Add Driver. If you clicked Load driver in step 3, clickOpen.The selected drivers are injected and will be loaded to the operating system after you reboot thetarget server.Launching a restore from the CoreTo launch a restore from the Core:1. If the NICs on any system being restored are teamed (bonded), remove all but one of the networkcables.NOTE: AppAssure Restore does not recognize teamed NICs. The process is not able to resolvewhich NIC to use if presented with more than one active connection.2. Navigate back to the Core server and open the Core Console.3. On the Machines tab, select the machine from which you want to restore data.4. Click the Actions menu for the machine, click Recovery Points to view a list of all recovery points forthat machine.5. Expand the recovery point from which you want to restore, then click Rollback.6. In the Rollback dialog box, under Choose Destination, select Recovery Console Instance.7. In the Host and Password text boxes, enter the IP address and the authentication password for thenew server to which you want to restore data.NOTE: The Host and Password values are the credentials you recorded in the previous task. Formore information, see Loading A Boot CD.8. Click Load Volumes to load the target volumes to the new machine.Mapping volumesYou can choose to map volumes to the disks on the target server automatically or manually. Forautomatic disk alignment, the disk is cleaned and repartitioned and all data is deleted. The alignment isperformed in the order the volumes are listed and the volumes are allocated to the disks appropriatelyaccording to size, and so on. Multiple volumes can use a disk. If you manually map the drives, you cannotuse the same disk twice.For manual mapping, you must already have the new machine correctly formatted before restoring it. Formore information, see Launching A Restore From The AppAssure Core.To map volumes:1. To automatically map volumes, do the following:a. In the RollbackURC dialog box, select the Automatically Map Volumes tab.b. In the Disk Mapping area, under Source Volume, verify that the source volume is selected andthat the appropriate volumes are both listed beneath and are selected.c. If the destination disk that is automatically mapped is the correct target volume, selectDestination Disk.d. Click Rollback, and then proceed to step 3.2. To manually map volumes, do the following:a. In the RollbackURC dialog box, select the Manually Map Volumes tab.b. In the Volume Mapping area, under Source Volume, verify that the source volume is selected andthat the appropriate volumes are both listed beneath and are selected.135