Installing and removing sled components 1013 screw (4) 4 system board holderFigure 45. Removing the system board1 system board holder 2 system boardNext steps1 Install the systemboard.2 Followthe procedure listed inthe After working inside your systemsection.Related linksSafety instructionsBefore working inside your systemRemoving a heat sinkRemoving a processorRemoving memory modulesRemoving an SSD carrierRemoving the SSD backplaneRemoving the SSD cageRemoving the PCIe mezzanine cardRemoving the LOM riser cardInstalling the system boardAfter working inside your systemInstalling the system boardPrerequisitesCAUTION:Manyrepairsmayonlybedonebyacertifiedservicetechnician.Youshouldonlyperformtroubleshootingandsimplerepairs as authorized in your product documentation, or as directed by the online or telephone service and support team.Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat came with the product.NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should beperformed only by Dell certifiedservice technicians.NOTE: You must remove the system board to replace a faulty system board.1 Followthesafetyguidelineslistedinthe Safetyinstructions section.2 FollowtheprocedurelistedintheBefore workinginside yoursystemsection.3 Remove the system board.4 Unpack the new system board assembly.5 Keep the Phillips #2 screwdriver, the 4 mm and 5 mm Hex nut drivers ready.
