32 Pre-operating system managementapplicationsDeleting or changing system and setup passwordPrerequisitesNOTE: You cannot delete or change an existing system or setup password if the Password Status is set to Locked.Steps1 To enter System Setup, press F2 immediately after turning on or restarting your system.2 On the System Setup Main Menu screen, click System BIOS > System Security.3 Onthe SystemSecurityscreen, ensure that PasswordStatusissetto Unlocked.4 In the System Password field, alterordeletetheexistingsystempassword, andthenpress Enter or Tab.5 In the Setup Password field, alter or delete the existing setup password, andthen press Enter or Tab.If you change the system and setup password, amessage prompts you to reenter the new password. If you delete the system andsetuppassword, amessageprompts youtoconfirmthedeletion.6 Press Esc to return to the System BIOS screen. Press Esc again, andamessage promptsyoutosavethechanges.Related linksSystem SecurityOperating with a setup password enabledIf Setup Password is set to Enabled, type the correct setup password before modifying the system setup options.If you do not type the correct password in three attempts, the system displays the following message:Invalid Password! Number of unsuccessful password attempts: System Halted! Must power down.Even after you turn off and restart the system, the error message is displayed until the correct password is typed. The following optionsare exceptions:• If System Password is not set to Enabled and is not locked through the Password Status option, youcanassign asystempassword.Formoreinformation,seetheSystemSecuritySettingsscreensection.• You cannot disable or change an existing system password.NOTE: You can use the password status option with the setup password option to protect the system password fromunauthorized changes.Related linksSystem SecuritySecure Boot Custom Policy SettingsSecure Boot Custom Policy Settings is displayed only when Secure Boot Policy is set to Custom.Viewing Secure Boot Custom Policy SettingsTo view the Secure Boot Custom Policy Settings screen, perform the following steps:1 Turn on, or restart your system.2 Press F2 immediately after you see the following message:F2 = System SetupNOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then restartyoursystemandtryagain.3 Onthe System Setup Main Menu screen, click System BIOS.