68 Installing and removing sled componentsRelated linksSafety instructionsBefore working inside your systemAfter working inside your systemTroubleshooting an internal SD cardInstalling an internal SD cardInstallinganinternal SDcardPrerequisitesCAUTION: Manyrepairsmay onlybedonebyacertifiedservicetechnician. You shouldonlyperformtroubleshooting andsimplerepairsasauthorizedinyourproductdocumentation, orasdirectedbytheonlineortelephoneserviceandsupportteam.Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthatareshippedwithyourproduct.1 Followthesafetyguidelineslistedinthe Safetyinstructions section.2 FollowtheprocedurelistedintheBefore workinginside yoursystemsection.3 If applicable, remove the SD card.NOTE: To use an SD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.Steps1 Locate the SD card connector on the internal dual SD module. Align the keyed end of the SD card into the slot and insert the card intothe slotNOTE: The slot is keyed to ensure correct insertion of the card.2 Press the card into the card slot to lock it into place.Figure 19. Installing an internal SD card1 SD card slot 2 SD card