20 Initial system setup and configuration4Initial system setup andconfigurationSetting up your systemComplete the following steps to set up your system:1 Unpack the sled.2 Remove the I/O connector cover from the sled connectors.CAUTION: Whileinstalling the sled, ensure that it is properly aligned with the slot on the enclosureto prevent damageto thesled connectors.3 Installthesledintheenclosure.4 Turn on the enclosure.NOTE: Wait for the chassis to initialize before you press the power button.5 Turn on the sled by pressing the power button on the sled.Alternatively, you can also turn on the sledbyusing:• TheslediDRAC.Formoreinformation,seethe LogintoiDRACsection.• TheenclosureChassisManagementController(CMC),aftertheslediDRACisconfiguredontheCMC.Formoreinformation,seetheCMCUser’s Guide at Dell.com/idracmanuals.Related linksLog in to iDRACiDRAC configurationThe Integrated Dell Remote Access Controller (iDRAC) isdesigned to make system administrators more productive and improve theoverall availability of Dell systems. iDRAC alerts administrators to system issues, helps them perform remote system management, andreduces the need for physical access to the system.Options to set up iDRAC IP addressYou must configure the initial network settings based on your networkinfrastructuretoenablethecommunicationtoandfrom iDRAC. Youcan set up the IP address byusing one of the following interfaces:Interfaces Document/SectioniDRAC SettingsutilityDell DeploymentToolkitDell LifecycleControllerSee Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanualsSee Dell Deployment Toolkit User’s Guide at Dell.com/openmanagemanualsSee Dell Lifecycle Controller User’s Guide at Dell.com/idracmanualsCMC Web interface See Dell Chassis Management Controller Firmware User’s Guide at Dell.com/esmmanuals
