Denso GT10B-SB User Manual

Contents

227.1.3 Verification result output(1) Report of match/mismatch statusYou can select any of the following report types by using the bar-coded parameter menu or configuration software(ScannerSetting). Selecting "Disable transmission" reports nothing.Setting If there is a match: If there is a mismatch:1 Disable transmission. Disable transmission.2 Enable bar code data transmission. Disable transmission.3 Enable bar code data transmission. Enable NG transmission.4 Enable OK transmission. Enable NG transmission.(2) Beeper, indicator LED and vibratorYou can check whether the verification result is a match or mismatch, with the beeper, indicator LED and vibrator.When the beeper, indicator LED and vibrator are enabled, they act as listed below.VibratorBeeper Indicator LED "OK" vibrations "NG" vibrationsIf there is a match: Emits a short beep. Lights in blue. Operates. --If there is a mismatch: Emits a long beep. Lights in red. -- Operates.(3) Scan lockThe scan lock function locks the scanner on standby if the verification result is a mismatch. You can enable or disablethis function with the bar-coded parameter menu or configuration software (ScannerSetting).Once the scanner is locked, it switches to standby regardless of the current trigger switch control selected. The scannerremains on standby even if the trigger switch is pressed or a ready-to-scan command (R, READON or LON) isreceived.Pressing the magic key or reloading the battery cartridge releases the scan lock.Note: In the data verification mode, the magic key is used to register a master bar code, not used to break theBluetooth® wireless link. To break the link, scan the "Break Bluetooth® wireless link" bar code. Note that whenthe scanner, as a master, is searching for a connection target or it is, as a slave, waiting for a master to connect, themagic key can break the Bluetooth® wireless link. See Section 2.3 for the "Break Bluetooth® wireless link" barcode.Note: Removing the battery cartridge clears master data stored in the scanner.Note: In any of the following cases, the scan lock is disabled regardless of the current setting.- When the "End operation" is selected- When the Bluetooth® wireless link is broken, except when the "Scan w/ Bluetooth® wireless link broken" isselectedNote: Breaking and connecting the Bluetooth® wireless link does not release the scan lock. Clearing the masterdata stored releases the scan lock.