Eaton PRC-E Series Instruction Manual

Contents

17LCD touchscreen display programmingPRC-E Series Instruction Manual MN014003EN August 2015 www.eaton.comLCD touchscreen display programmingIntroductionThe PRC-E Series controllers are equipped with a 2.25” x3.75” resistive LCD touch screen. The touch screen hasgraphic icons that are used to navigate through the menusof the controller, input data, configure the controller, andinitiate commands to control functionality. Throughout thismanual the word “touch” or “tap” will be used to describethe action of choosing the icon on the LCD touch screen.otee:N Some icons have touch time delays to help alleviateerrors due to multiple button presses.The following LCD instructions follow the process of theinitial commissioning of a panelboard. Each screen will becovered, but not in the order as displayed. LCD access canbe secured by an optional Pin-code which can be set inthe software.otee:N The BCB installation, addressing and correct cablingis crucial to the successful control of the controllablecircuit breakers. See the “BCB installation” sectionon page 78 for further information on cabling andcorrect state of the status LEDs on the BCB.In the idle state, the LCD will have a blank screen.Log-inTap the LCD screen of the PRC-E controller.This will “wake up” the LCD display. A splash screen willbriefly appear, then the “Intro” screen will display. Thisscreen displays following information:●● Name and Description of the controller●● IP address of the controller●● Status of groups A through P●● Controller type, Address, and Firmware revision●● Time, Day, and DateIn the top right corner, the “Intro” screen will have a buttoncalled “Log-In”, if a pin-code for the LCD has been previouslyset, or “Start”, if a Pin-code has not been set.If the “Log-In” button is present,Tap “Log-in” button.This will display the “Enter Pin-code” screen.