Eaton PRC-E Series Instruction Manual

Contents

73Web page programmingPRC-E Series Instruction Manual MN014003EN August 2015 www.eaton.comSetting the analog point “Action”Click the analog “Action” dropdown arrow next to the buttonto be programmed.This opens the dropdown list for a quick pick of theactions available.Click to select the required action.None: No analog point action commanded.Set: The analog point chosen will be set to the setting in the“Value” input box.Inc: Increment; the analog point chosen will be incrementedby the setting in the “Value” input box.Dec: Decrement; the analog point chosen will bedecremented by the setting in the “Value” input box.Setting the analog point adjustment “Value”Click the “Value” input box of the button to be programmed.This opens the input box for edit.Input the required numeric value for the analog adjustmentusing the keyboard. Remember, this value will be used bythe analog action to adjust the selected analog point. Thiswill be the set value of the analog output or the setpoint ofthe closed-loop feedback from the photocell.The “Feedback Point” controls the indicator LED of eachbutton. An active button command can illuminate the LED ofthat button. This point can be a circuit breaker, flag, analogpoint (value), etc.“Default” is checked by default. With this active, the digitalswitch feedback point textbox is inaccessible. The defaultpoint will be set as follows:Digital point: If the digital point action is set and there isno analog setup, the button will illuminate when the digitalpoint is ON.“LIGHT_LVL”: If the “LIGHT_LVL” point is selected and the“Set” analog action is selected, the button will illuminatewhen the digital switch analog output is equal to the setvalue.If any other analog actions are selected, the default willbe blank.To edit the default feedback indication point, uncheck thedefault box.Click the “Feedback Point” dropdown arrow next to thetextbox of the button to be programmed.This opens the dropdown list for a quick pick of somecommon points.If the point required is not in the list, the textbox can beedited using the keyboard to enter the address.To edit the “Feedback” textbox, click the “Feedback Point”textbox of the button to be programmed.This opens the textbox for editing.