CHAPTER 8 - PXG600E CONFIGURATION WEB PAGE123EATON PXG600E User Manual • IM02603003E Rev 5, 11-May-2012 • Firmware Version 5.03:3835Email Parameters for All Recipients1. Click on the EMAIL link (Figure 127, A) in the toolbar of the PXG600Econfiguration web page.NOTICE: When you enter the configuration for any ApplicationServer (such as Access Control and email) you will be asked forthe address of the host or server. If you enter the name of theserver instead of the IP address you MUST enter the IP addressof at least one Domain Name Server in a Name Server boxManually Enter IPv4 Address on page 103.2. Enter the SMTP Server IP / Hostname (Figure 127, B).3. Enter the SMTP Username (Figure 127, C). This is an optional entry.This entry is only required if your SMTP server requires a username andpassword to SEND an email.4. Enter the SMTP Password (Figure 127, D). This is an optional entry.This entry is only required if your SMTP server requires a username andpassword to SEND an email.Figure 1275. Enter the From address (Figure 127, E). This will be the address of thesender when the emails are sent. The address can be up to 40 alphanumeric characters. Special characters include the “@” symbol and “_”underline. The default value is “PowerXpert.Gateway@eaton.com.”PXG600E_362BCEDFAHGJL KMNI
