CHAPTER 8 - PXG600E CONFIGURATION WEB PAGE127EATON PXG600E User Manual • IM02603003E Rev 5, 11-May-2012 • Firmware Version 5.03:3835Time SettingsTime Settings allows you to synchronize the PXG600E with the NetworkTime Protocol (NTP) servers, or you can manually enter the time and date. Ifyou choose to use the NTP, you may use the default NTP addresses or enteran IP address or host name of the NTP server(s) you would like to use. Thedefault NTP servers may not be accessible due to your corporate IT securityfirewall settings. Therefore, you may choose to enter your own settings. It isrecommended that you do this prior to adding devices to the device list. Thiswill ensure that the data reported to Power Xpert Software is correctly time-stamped.1. Click on the DATE/TIME link (Figure 130, A) in the toolbar of thePXG600E configuration web page.Figure 1302. If you leave the “Synchronize with NTP server(s)” box (Figure 130, B)checked, you can designate the NTP server(s) that you want to use.3. If you leave the “Synchronize with NTP server(s)” box (Figure 130, B)checked, the current “NTP Status” is shown (Figure 130, C). Sometypical status statements are:Not RunningStarted, not synchronizedSynchronizing with NTP serverSynchronized to aaa.bb.cc, NTP stratum 1 (where “aaa.bb.cc” is theaddress of the NTP server)PXG600E_365AEFGDB CHI
