CHAPTER 14 - TROUBLESHOOTING AND MAINTENANCE183EATON PXG600E User Manual • IM02603003E Rev 5, 11-May-2012 • Firmware Version 5.03:3835Resetting Lost Passwords and IP AddressesIf you customized either the User or Admin password and have misplacedthem, follow this procedure to reset the password(s) to the factory defaultvalues.Also follow this procedure if you need to reset the IP addresses.NOTICE: All the other configuration information of your PXG600Ewill be maintained when you follow the procedure exactly. TheRestart button (Figure 191, A) restores the factory default settingsfor the static IP address, User Password and Admin Password. Allother configuration settings will be retained. Press the switch for atleast 3 seconds, but no more than 10 seconds. If you hold switch for15 seconds, the entire configuration is reset to factory values.Figure 1911. Connect the PXG600E to the Windows computer using a USB AB cable.Connect one end of the USB cable to an empty USB port on yourcomputer and the other end to the USB port on the PXG600E.2. Press the Restart button (Figure 191, A) and hold it for at least threeseconds, but less than 10 seconds. You will reset the IP address for anEthernet LAN connection to a static value of 192.168.1.1 and reset theUser and Admin passwords to the factory default values. All the otherconfiguration information of your PXG600E will be maintained.3. Release the button. The default settings will load and the unit willreboot.4. Wait at least two minutes for the PXG600E to completely reboot.5. Close the browser and reopen it.6. The PXG600E can be accessed using the following settings:User PasswordUser Name: userPassword: userAdmin PasswordUser Name: adminPassword: admin7. To customize these passwords, follow the steps in Configuration ofPassword on page 99.PXG600E_188COM 1INCOMCOM 1RESTARTSHLDD2D1CMNA (-)B (+)+ VGND1 2PXG 600E24 VDCUPSTREAM DOWNSTREAMCOM 2ABCMNA (-)B (+)COM 2BAINCOMA
