Eclipse EC-P50 Installation Manual
Also see for EC-P50: User manual
                                                    | |
Contents
| 
P0016-LI-03.01 35Listed below are the GPRS setting used by the major UK GSMnetwork operators:Operator APN User PasswordVodafone internet web webOrange Orangeinternet * *O2 Mobile.o2.co.uk web webT-Mobile General.t-mobile.uk * *Three 3internet * ** = Leave blank.SIM PinIf the SIM is protected by a PIN, then the number must be enteredin this location in order for correct operation.SIM Credit CodeIf the GSM network operator supports credit balance via USSD,then enter the USSD code, e.g., *123#.SMS Service Centre NumberThe system can send SMS messages to mobile telephones via thestandard PSTN telephone network. To achieve this, it uses theETSI ES 201 912 protocol 1. This protocol is not supportedworldwide so please check with your telephone provider. Listedbelow are the SMS Centre numbers for supported countries andoperators:Country Operator SMS Centre NumberUK BT 17094009Ireland Eirecom 17409900Germany T-Com 0193010Belgium Belgacom 14974800France France Telecom 0809101000Switzerland Swisscom 0622100000Netherlands KPN Telecom 0673644444South Africa Telkom 1091969Caller Line Identity must be enabled in order for the SMS ServiceCentre to accept the message.IP ConfigurationThese options allow the IP details to be configured and arerequired when using the EC-COM/IP module.Locations: 6401 - IP Address6402 - Subnet Mask6403 - Gateway Address6404 - Port NumberEntry Mode: String Edit - Number Mode (see page 18).IP AddressA valid IP address must be assigned to the module. It must beentered in dot-decimal notation, e.g. “192.168.0.58”. Enter B3to insert a “.”.Subnet MaskThe subnet mask used on the network must be assigned to themodule. It must be entered in dot-decimal notation, e.g.“255.255.255.0”. Enter B3 to insert a “.”.Gateway AddressThe gateway address (normally the ADSL router) used on thenetwork must be assigned to the module. It must be entered indot-decimal notation, e.g. “192.168.0.1”. Enter B3 to insert a“.”.Port NumberA valid port number must be assigned to the module. It must beentered as a decimal number, e.g. “8888”. |
Related manuals for Eclipse EC-P50
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine