CHAPTER 4: INTERFACES ENERVISTA SOFTWARE INTERFACEC70 CAPACITOR BANK PROTECTION AND CONTROL SYSTEM – INSTRUCTION MANUAL 4-74Figure 4-6: Applying templates using the View in Template Mode settings commandUse the following procedure to display settings available for editing and settings locked by the template.1. Select an installed device or a settings file from the tree menu on the left of the EnerVista UR Setup main screen.2. Apply the template by selecting the Template Mode > View All Settings option.3. Enter the template password then click OK to apply the template.Once the template has been applied, users are limited to edit the settings specified by the template, but all settings areshown. The effect of applying the template to the phase time overcurrent settings is shown as follows.Figure 4-7: Applying templates using the View All Settings command4.1.6.5 Remove the settings templateIt can be necessary at some point to remove a settings template. Once a template is removed, it cannot be reapplied anda new settings template needs to be defined before use.1. Select an installed device or settings file on the left side of the EnerVista UR Setup window.2. Right-click and select the Template Mode > Remove Settings Template option.3. Enter the template password and click OK to continue.Typical settings tree view without template applied. Typical settings tree view with template applied viathecommand.Template Mode > View In Template Mode842860A1.CDRPhase time overcurrent settings window without template applied. Phase time overcurrent window with template applied viathe command.The template specifies that only the andsettings be available.Template Mode > View All SettingsPickup Curve842859A1.CDR
