5-50 C70 CAPACITOR BANK PROTECTION AND CONTROL SYSTEM – INSTRUCTION MANUALPRODUCT SETUP CHAPTER 5: SETTINGS5Figure 5-13: IEC 61850 TxGOOSE panelTxGOOSE1 FUNCTIONRange: Enabled, DisabledDefault: EnabledWhen set to Disabled, TxGOOSE1 messages are not published. When set to Enabled, TxGOOSE1 messages are published.When TxGOOSE1 to 8 are set to Disabled in EnerVista and subsequently Enabled by writing via MMS, the panel continuesto read Disabled until relaunched. There is no polling capability to update automatically the IEC 61860 readings, so thepanel needs to be closed then opened for the correct status to display.TxGOOSE1 GoIDRange: 0 to 129 VisibleString charactersDefault: TxGOOSE1The entered value sets the goID value published in TxGOOSE1 messages, and can be used by subscribers to discriminatethe TxGOOSE1 messages from other GOOSE messages.TxGOOSE1 DatSetRange: None, DataSet01, DataSet02,...Default: NoneThis setting selects the published data set using the UR Setup software designator for the data set. The IEC 61850 nameof the data sets are configured in the Datasets panel, as described later.An ObjectReference to the data set, which consists of the concatenation of the string "/LLN0." and the dataset name, is published in the datSet field of TxGOOSE1 messages and can be used by subscribers to discriminateTxGOOSE1 messages from other GOOSE messages.TxGOOSE1 DST MACRange: any 12 digit hexadecimal numberDefault: 01-0C-CD-01-00-00The value entered sets the Ethernet destination Media Access Control (MAC) address in published TxGOOSE1 messages.As the standard requires that the address have the multicast bit set TRUE, that is to say the second digit is set to an oddnumber, messages transmitted have the multicast bit set TRUE no matter its value in this setting.The destination MAC address can be used by the network to restrict message delivery to selected devices that need toreceive them, reducing network loading. This address also can be used by hardware in receiving devices to filter outmessages that are of no interest to them, reducing processor burden. Different filtering algorithms are implemented bydifferent devices. The standard recommends that the algorithm used by hardware of the receiving device be consideredwhen assigning destination multicast addresses.Subscribers can use this address to discriminate TxGOOSE1 messages from other GOOSE messages.
