CHAPTER 5: SETTINGS REMOTE RESOURCESC70 CAPACITOR BANK PROTECTION AND CONTROL SYSTEM – INSTRUCTION MANUAL 5-1115unreturned messages. This function counts all the outgoing messages and a separate counter adds the messages havefailed to return. When the unreturned messages counter reaches the user-definable level specified by the UNRET MSGSALARM CH1 THRESHOLD setting and within the user-defined message count UNRET MSGS ALARM CH1 COUNT, the DIR IO CH1UNRET ALM FlexLogic operand is set.When the total message counter reaches the user-defined maximum specified by the UNRET MSGS ALARM CH1 MESSAGECOUNT setting, both the counters reset and the monitoring process is restarted.Configure the operand to drive an output contact, user-programmable LED, or selected communication-based output.Latching and acknowledging conditions, if required, are programmed accordingly.The unreturned messages alarm function is available on a per-channel basis and is active only in the ring configuration.The total number of unreturned input and output messages is available as the ACTUAL VALUES STATUS DIRECT INPUTS UNRETURNED MSG COUNT CH1 actual value.5.3.17 InstallationSETTINGS PRODUCT SETUP INSTALLATIONTo safeguard against the installation of a relay without any entered settings, the unit does not allow signaling of anyoutput relay until RELAY SETTINGS is set to "Programmed." This setting is "Not Programmed" by default. The UNIT NOTPROGRAMMED self-test error message displays until the relay is put into the "Programmed" state.The RELAY NAME setting allows the user to uniquely identify a relay. This name appears on generated reports.5.4 Remote resources5.4.1 Remote resources configurationWhen the C70 is ordered with a process card module as a part of HardFiber system, an additional Remote Resourcesmenu tree is available in the EnerVista software to allow configuration of the HardFiber system.Figure 5-46: Remote Resources configuration menu INSTALLATION RELAY SETTINGS:Not ProgrammedRange: Not Programmed, Programmed RELAY NAME:Relay-1Range: up to 20 alphanumeric characters
