CHAPTER 5: SETTINGS PRODUCT SETUPC70 CAPACITOR BANK PROTECTION AND CONTROL SYSTEM – INSTRUCTION MANUAL 5-315Rolling Mode Page 1 to 10Range: Product Information, SLD 1…5, Annunciator, Annunciator 1…8, Phasors 1…6, Tabular 1…5, Event Records, TargetsDefault: Product InformationThese settings specify the pages to display on the graphical front panel while in rolling mode.The "Annunciator" selection without a page number specifies the first annunciator page in the following sequence:– The first annunciator page that contains an annunciator window that is in alarm (fast flash)– The first annunciator page that contains an annunciator window that is in ringback. Ringback is a "return alert."Visual and audible signals are given when conditions return to normal, then the sequence returns to normal bypushing the RESET button.– The first annunciator page that contains an annunciator window that is in abnormal state– Annunciator page 1Whenever an annunciator window changes state the list is re-evaluated, which can result in the display of a differentannunciator page in the rolling sequence.The Tabular option displays a configured actual values/metering page.The Targets option displays error messages, such as wrong transceiver, similar to event record entries.5.3.3.3 Metering editorThis feature creates tables of actual/metered values for the graphical front panel. It configures the content that displays inthe Metering Tab pushbutton. An actual value, status, or text can be displayed. Five tabular metering pages can beconfigured. There also can be a phasor page for each configured AC source, and these pages are not configurable.The path is Settings > Product Setup > Graphical Panel > Metering Editor.Set the Current Page, Page Name, Layout, configure the top inputs, then the cells. The 16 inputs at the top of the page areused as inputs for the Status Index fields. Click the Preview button to view the page.For a phasor diagram, configure the source under Settings > System Setup > Signal Sources. The diagram is thenviewable by pushing the Metering Tab pushbutton on the graphical front panel. The Metering Editor is not used for thesephasor diagrams.The figures show setup and table preview.
