CHAPTER 5: SETTINGS PRODUCT SETUPD30 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL 5-1355.3.1.3 EnerVista securityEnable the security management systemThe EnerVista security system allows an administrator to manage access privileges of multiple users of EnerVista.It is disabled by default to allow access to the device immediately after installation. When security is disabled, all usershave administrator access. GE recommends enabling the EnerVista security before placing the device in service.To enable the security system and require password use:1. Select the Security > User Management menu to open the user management window.2. Enable the Enable Security check box in the lower-left corner to enable the security management system.3. Click the Ok button.Security is now enabled for the EnerVista UR Setup software. Upon starting the software, users are now required to enter ausername and password.Add a new userThe following pre-requisites are required to add user accounts to the EnerVista security management system:• The user adding the account must have administrator rights• The EnerVista security management system must be enabled (previous section)To add a user account:1. Select the Security > User Management item from the top menu to open the user management window.2. Enter a username in the User field. The username must be four to 20 characters in length.If you force password entry by using this feature, ensure that you know the Administrator password. If you do notknow the password and are locked out of the software, contact GE Grid Solutions for the default password of a URdevice. When using CyberSentry, the default password is "ChangeMe1#".
