GE Multilin D30 Line Distance Protection System 5-315 SETTINGS 5.2 PRODUCT SETUP5The fixed GOOSE settings are shown below:PATH: SETTINGS PRODUCT SETUP COMMUNICATIONS IEC 61850 PROTOCOL GSSE/GOOSE CONFIGURATION TRANSMISSION FIXED GOOSEThese settings are applicable to fixed (DNA/UserSt) GOOSE only.The GOOSE ID setting represents the IEC 61850 GOOSE application ID (GoID) name string sent as part of each GOOSEmessage. This string identifies the GOOSE message to the receiving device. In revisions previous to 5.0x, this name stringwas represented by the RELAY NAME setting.The DESTINATION MAC setting allows the destination Ethernet MAC address to be set. This address must be a multicastaddress; the least significant bit of the first byte must be set. In D30 releases previous to 5.0x, the destination EthernetMAC address was determined automatically by taking the sending MAC address (that is, the unique, local MAC address ofthe D30) and setting the multicast bit.The GOOSE VLAN PRIORITY setting indicates the Ethernet priority of GOOSE messages. This allows GOOSE messages tohave higher priority than other Ethernet data. The GOOSE ETYPE APPID setting allows the selection of a specific applicationID for each GOOSE sending device. This value can be left at its default if the feature is not required. Both the GOOSE VLANPRIORITY and GOOSE ETYPE APPID settings are required by IEC 61850. FIXED GOOSEGOOSE FUNCTION:DisabledRange: Enabled, DisabledMESSAGE GOOSE ID:GOOSEOutRange: 65-character ASCII stringMESSAGE DESTINATION MAC:000000000000Range: standard MAC addressMESSAGE GOOSE VLAN PRIORITY:4Range: 0 to 7 in steps of 1MESSAGE GOOSE VLAN ID:0Range: 0 to 4095 in steps of 1MESSAGE GOOSE ETYPE APPID:0Range: 0 to 16383 in steps of 1
